Quote:
Originally Posted by MatteoBounce
clicking the left mouse button on the software manually (pokerstars).
here are screenshots of my hotkeys & advanced settings
http://i.imgur.com/x7iD0J8.jpg
or could this have to do with stars settings?
everything else works fine now.
The only relevant setting is in Advanced Options for "Left mouse click detection". You have that turned on which is correct, that is how SaT will detect the mouse clicks within the button ranges.
If the table is moving into the grid, then that means that SaT has detected a click within a button region. But you say the button itself isn't being clicked, which means PokerStars isn't registering the click.
Probably this is happening when you are playing a decent amount of tables and clicking around fast. My guess is one of two scenarios is happening, and I would like you to test both. Open up just one table and put the table in the stack. Then when its your turn to act, try clicking very slowly and deliberately on Call or Bet. The table should correctly move into the grid. This is the normal case.
Now, there are two edge cases. Put the table back into the stack, and wait for your turn to act. First, click DOWN on Call/Bet and hold the click down. Stars should highlight the button somehow to visually indicate the button is down. But then while still holding the click down, move your mouse outside of the button, and then release. In this case, Stars should NOT register the click, since when you RELEASED the click, your mouse location was outside the button. Test that and see if SaT incorrectly moves the table into the grid.
Next, test the opposite. Click down OUTSIDE of the buttons, hold the click down, and then move the mouse over the button, and release the click while over the button. And see what happens with both Stars and SaT.
Quote:
Originally Posted by MatteoBounce
its just a bit impractical with the "after entering pot" tile-mode, its the same as with timed out tables. i set up a hotkey to start/stop SaT to drag out the needed tables. thats an okayish workaround. nbd
Ah yes, if you are moving New Tables directly into the stack, then the Replayer will get lost in the stack. I assumed you were moving New Tables to the grid.