nive review, SiQ. one point that caught my attention is @6:35, scripting PioSolver. you mention you're not "savvy enough to figure out how to do that" -- I felt the same until i wanted to run a spot on 10 different flops and actually looked into the documentation. the good news is, it's extremely easy to do! you can find a good overview under
http://piosolver.com/pages/text-interface-scripting, especially the third sample script is helpful.
in order to script PioSolver, do the following:
- open an empty txt-file
- open PioViewer and set up OOP and IP ranges
- in the range selector, you can click on the Copy/Paste tab and choose Copy in PioSolver format (this will give you the range with just weights)
to set up the spot, script it like this:
- first line in the txt-file, type "set_range hero" and the paste OOP range after that
- new line, "set_range villain" and paste IP range after that
- "set_board" and type in the board after that, in the same format as you would in the viewer
- "set_bet_sizes" (same as in the viewer, cumulative etc)
- "set_pot" 0 0 X with X being the pot size
- "set_donk_bet" 0/1 (1 meaning yes)
to run the spot, type:
- "build_tree"
- "go 300 seconds" (or how long you want to run it)
- "wait_for_solver"
to save the solution, type:
- "dump_tree C:\PioSolver\test.cfr"
- to run a new spot after that, you can either redo all the previous steps or, if you want to run the same spot on just a different board, you can type:
- "set_board Xh Ys Zd"
- "rebuild_tree" (this will rebuild the tree as in your last setting, but consider the new board)
- "go 300 seconds"
- "wait_for_solver"
- "dump_tree C:\PioSolver\test2.cfr"
and so on.. example script with incomplete ranges that runs a 3bet spot on two flops:
_____________________________
set_range hero 1 1 1 0 0.1 ....
set_range villain 1 0 1 1 0.5 ...
set_board Ah Ks Qh
set_bet_sizes 10 30 90
set_pot 0 0 20
set_donk_bet 1
build_tree
go 600 seconds
wait_for_solver
dump_tree C:\PioSolver\AKQ.cfr
set_board 9h 8h 7h
rebuild_tree
go 600 seconds
wait_for_solver
dump_tree C:\PioSolver\987.cfr
exit
_____________________________
save the txt-file in the PioViewer folder. open PioSolver and type "load_script nameofyourscript.txt" and hit enter, it'll run the script (the one above will take 20 mins), save the solutions and exit the app. you can now run as many different spots as you like in an automated fashion, but be sure that your cpu isn't overheating.
edit: also be sure you have enough space on your hard-drive
Last edited by samooth; 03-25-2015 at 11:15 AM.