Quote:
I see that the calculator starts off by showing nash ranges. the games im playing on ignition are filled with players that dont even know what icm is, and call infinitely wider than nash. How can I most efficiently use hrc to learn correct push/call ranges?
You'd typically start out with the Nash ranges and adjust opponent's ranges based upon your reads. After that use the green "Run Nash Calculation" button to re-adjust all unlocked ranges. You typically do NOT want to use the "Set Best Response" option, as this is re-adjusting only the single selected range.
Quote:
when i open the hand range dialog box and put a figure in like 16.3% for example, sometimes it shows some hands, and sometimes others. In other words, if I change it to some other range, then put it back to 16.3, the actual hands selected are noticably different than they were the first time.
also, the best response ranges are different when I run them more than once. In one case it told me to call with AJo+ when villian is shoving 16.0%, then it told me to only call AQo+ when villian is shoving 16.5%.
It will even give different calling ranges when I run the exact same villian shoving range more than once, by changing it and putting it back.
Most likely the other ranges on the table were changed between that. When you enter 16.3%, the program selects the 16.3% with the highest EV. If you then e.g. re-adjust some other range and later attempt to set the same 16.3% number, the actual hand selection might be different now. This would be working as intended.
If you still believe there is an issue then please upload the hand via Hand: Share hand and let me know the exact steps to reproduce the issue.
Quote:
Also, it doesn't seem to be recognizing antes in my Ignition HHs.
Please send a few ante HHs to
support@holdemresources.net and we'll get them supported asap.