mister fancy lad exceeded expectations achievement boy
Join Date: Aug 2009Posts: 1,479
I'll get you a picture, but basically I'm putting a utility sink(U/S) and a Washer drain(W/D) about 13 ft away from the current stack. I was planning to have 1.5" horizontal run from the U/S to a 1.5x2 that ties into the W/D. Do I need to vent them separately, do I need to connect the vent to the current vent stack. Can I make a local vent, or two, work?
I also thought I could stack vent the 1.5, with a Sani t, then 90 to 1.5x2, then stack vent the W/D and tie those two vents together.... but then I'd have to drop a bunch of holes in the faux 2x6 half wall I built.
mister fancy lad exceeded expectations achievement boy
Join Date: Aug 2009Posts: 1,479
Heres the setup, those two vents are my problem, I don't wasn't to drill two holes through every stud in this wall which is a total of 7 from here to the end... I'll need to keep the 2" with a .25"/1' slope once they tie together
mister fancy lad exceeded expectations achievement boy
Join Date: Aug 2009Posts: 1,479
This is the final concept, the 1.5 vent travels sloped upward towards the vent pipe and will tie in with a Sani t, the drain line slopes towards the tie in with a Sani t, the vent pipe is going above the wall cause **** cutting all those holes