Can someone tell me what the default table size is for Merge? I prefer the mini mode setting, and I'm wanting to six table on a 24 inch monitor. Is a 1920x1080 going to be ok, or do I need a 1920x1200?

Thanks!!

I have a 23 inch 1920x1080 that I tile 8 tables with in normal mode. I think either resolution should be fine with 6 mini tables on a 24 inch

I do shrink the tables so I can see my cards at all the tables at once, but there is overlap.

thanks. I want to tile 6 tables with no overlap. should have put that in the OP.

Thanks for the help here. Sounds like you'll be good to go for 6-tabling then.

Chris,

Can you find out the pixel size of default tables please?

I don't know what the pixel size is, but I opened up 6 tables in mini mode and tiled them with no overlap and the tables will be touching at the sides and leave a decent gap in the middle of the screen. The 1200 will give you extra pixels vertically that you don't really need.

thank you!!

Not sure what default is, the minimums are below.

Mini mode: width: 421 height: 324

Normal mode: width: 631 height: 474

I have requested the size from Merge and await their reply.

Thanks for the input ptwp330.

Thanks Max Cut. I'm waiting for Merge to reply, so I will be able to give a confirmed answer soon.

The default pixel size is 1280x960px.

Let me know if you need anything else.

in after 6.0........ in mini mode, I used to be able to adjust off of the 1.3:1 ratio. In other words, I could have an absolutely square table if I wanted (not sure if this is a result of using PlaceMint, MergeKeys....or Merge softeware. ((The tables appeared a tad squeezed, but definitely readable.))

Would like to be able to do the same in 6.0. Possible......or does anyone know if that was a product of PlaceMint or Mergekeys instead?

Thanks

I think the ratios of the table are set, and no matter how large or small you make the table, it still needs to conform to the ratio set.

Ryan